Home | Computer
VGA to Component Video Convertor enables you to change a VGA signal to Component Video, S-Video or Composite Video. The reason you require a converter and not just a device is that a VGA to Component Video Cable will not change the signal; the device is used primarily to adjoining the component video through a VGA connector on some projectors. The VGA to Component Video is similar to our "PC to TV" convertor but has Component Video outputs via three colour-coded (red, green, blue) devices. It is ran through a USB port on the computer. VGA connector , is a three-row 15-pin DE-15 connector, device of which there are four versions : (i)The original - VGA15 pin - out connector (ii)DDC2 pin - out connector (iii)The older, less bendable DE-9 connector (iv)The Mini-VGA used for laptop computers. A Video Graphics Array (VGA) signal carries information over a device to show visual data, typically on a computer monitor, LCD screen or high-definition television. The VGA device is made up with four-sided plugs on both ends including 15 pins, arranged in three rows. The plugs connect safely with two locking screws like older printer-cable screws. While not all graphics devices are equipped with a VGA jack, converting the VGA signal to component video (which most devices have) needs an adapter sold at electronics and computer stores. This may be a desirable connection for hooking up a laptop to an HDTV, for example. So to connect it for use you will require the following instructions: 1. Link the VGA device to the device that produces the VGA graphic signal by placing the plug on one end of the cable straight into the jack. The plug goes in with the wider edge turned upward and all pins aligned with the holes in three rows inside the VGA connector. 2. Tighten the locking bolt clockwise by hand on each side of the VGA plug to secure it to the connector. 3. Insert the other end of the VGA cable into the adapter, which has a VGA connector on one end with 15 holes in three rows. Hold this connection with the locking bolts 4. Connect the plugs on the other ends of the adapter device to component video jacks on a computer monitor or television screen. The RGB component device plugs are colour-coded to match up with the Red, Green and Blue component video devices on the monitor or television.
Article Source: http://www.casinoarticlessite.com
Please visit this link for more information on: VGA to component and this link for another interesting article on VGA to component.
Please Rate this Article
5 out of 54 out of 53 out of 52 out of 51 out of 5
Not yet Rated
